16
16
35 mm
5 m
m
4 m
m
1
2
13
14
12
13
1
600mm SRAM
650mm Shimano
155mm
Note orientation of DT clamps.
Small plate should be positioned
under the housing (parallel with
lines) with the rounded sides up
as shown. It is not side-specifi c,
however.
nOTICE
Incorrect clamp placement
can result in damage. Do not
over-tighten the clamp bolts.
Check for suffi cient housing cable loop. Its about 35mm as shown above.
Inadequate loop can result in ghost shifting or housing ends pulling out
of down tube when the bike is at full travel.
Its best to determine housing lengths with the shock out of the bike. That
way you can move the swing arm through the travel and actually see
what the cable housing is doing. It always looks like there is too much
cable housing when set up properly.
Photo shows crossing housing to prevent the rear derailleur housing
contacting the chainring. Or, a cable tie can be used.
Be sure to install nose end seals and rubber seal at the housing ends as
shown.
Summary of Contents for Trigger 26ER
Page 36: ...35 129920 PDF 35...
