2. At the Global Spanning Tree Parameters menu, type the number for an item and press <Enter>,
then follow the prompts to set values for these parameters:
•
Admin Mode: Enable or disable STP protocol.
•
Version: Shows which IEEE specification this meets; d = Standard; w = Rapid; s = Multiple
•
Configuration Name: Name for configuration, typically MAC address, up to 32 characters
•
Configuration Revision: Set a revision level between 1 and 65535
•
Priority: Set the relative precedence within the STP control structure for the 9161, from 1
(highest) to 65534 (lowest). The highest priority sets the root bridge, the bridge that controls
the spanning tree. If two or more bridges share the same priority, the lowest MAC address
defines the highest priority.
•
Hello Time (sec): Set how often the 9161 sends BPDUs if this 9161 is the Spanning Tree
root.
•
Forward Delay (sec): Set the time between port state transitions from Learning to Forward if
this bridge is the STP root.
•
Max Age (sec): Set the Timeout value, how fast the 9161 deletes addresses from the
forwarding database.
•
BPDU Forwarding Mode: Normal, Blocking, or Forwarding On Same VLAN
3. To view or update parameters for a specific port, type
10
, "View/Change Interface," and press
<Enter>, then press <Space> to cycle through the port names. You can edit various parameters,
such as Admin Mode, Priority, Path Cost, and Edge Port.
4. To return to the Switch Configuration menu, press <Esc>.
Set Up VLANs
Use the VLAN Configuration screen to view and set VLAN parameters for the 9161. To access the
VLAN Configuration screen, follow these steps:
1. From the Switch Configuration menu, type
5
, "VLAN Configuration," and press <Enter>.
2. At the VLAN Configuration screen, type
1
to add a VLAN or type
2
to view or edit VLAN
information and press <Enter>, then follow the prompts on the screen. You can view a specific
port or set the VLAN Name, up to 20 characters.
3. At the VLAN Configuration screen, to view a part of the VLAN list that does not appear on the
screen, type
4
, then enter the number of the VLAN where you want to start viewing the list.
4. To set up ID translation for a specific port, type
5
, then press <Space> to select that port; and
follow the prompts on the SP
x
VLAN ID Translation screen.
5. To set up Priority translation for a specific port, type
6
, then press <Space> to select that port;
and follow the prompts on the SP
x
VLAN Priority Translation screen.
6. To remove a VLAN, type
3
and press <Enter>, then type or select the VLAN number.
9161 Network Interface Device
3-23
Summary of Contents for 9161
