12-6
T
roubleshooting
LCD Messages
See the table below when the LCD displays error messages.
Message
Description
Action
ADJUSTING
WAITING TO SCAN
The machine is not ready for
scanning.
Wait until the machine is
ready.
AUTO REDIAL
This message appears when
the recipient is engaged in
direct sending and the job is
waiting.
Disappears when the
transmission restarts.
CHANGE PAPERSIZE
The size of the paper in the
paper cassette or multi-
purpose tray is different from
that of the paper specified in
<REG. PAPER SIZE> or
<MP TRAY STD SET> in the
<COMMON SETTINGS>
menu.
– Load the paper which size
is shown on the lower line
of the LCD display. Or
change the paper size
setting. Then reset the
machine by opening the
left cover and then closing
it.
– If you are trying to print a
report or list, set the paper
size to <LTR> or <LGL>,
then load paper of the
same size. Then reset the
machine by opening the
left cover and then closing
it.
CHANGE REG’D SIZE
→
COMMON SETTINGS
This message appears at the
same time when <LOAD
PAPER> is shown. You may
not print at the current paper
size.
Change paper on the paper
cassette or multi-purpose
tray. And you must also
change the size setting in
the <COMMON SETTINGS>
menu.
CHECK DOCUMENT
A document jam may have
occurred in the ADF.
Remove the jammed
document.
CLOSE COVER
A cover is open.
Close the cover shown on
the lower line of the LCD
display.
Summary of Contents for 0564B001
