1
2
3
4
5
6
7
8
9
10
11
Back
Next
Previous
TOP
4-34
Before Using the
Machine
Document and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network
Remote UI
System Manager
Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Dialing using the [R] Key
1.
Set
documents.
Place the first page on the platen glass if you are not using the ADF.
2.
Press [SEND/FAX] to select <FAX>, then press
[OK].
3.
Press [R] to access the outside line.
4.
Use the numeric keys to enter the fax number.
5.
Press
[Start].
When you set the documents on the platen glass, press [
] or [
]
to select the document size, then press [Start] for each document.
When scanning is complete, press [OK] to start sending.
When <TIME OUT> is set to <ON> in <TX SETTINGS> in <FAX
SETTINGS> in <TX/RX SETTINGS>, and if you have specified the
destination by any other method than using numeric keys, the
machine starts scanning automatically without pressing [Start], after
the preset time for this setting is elapsed.
Switching Temporarily to Tone Dialing
If your machine is set for pulse dialing, use the procedure below to
switch to tone dialing to use information services (e.g., banks, airline
reservations, and hotel reservations).
To talk to the other party, you will need to connect the optional handset or
an external telephone to the machine.
1.
Press
[SEND/FAX].
2.
Press [SEND/FAX] repeatedly to select <FAX>,
then press [OK].
3.
Press
[Hook].
You can also lift the optional handset instead.
Make sure to confirm the dial tone before entering a fax number. If
you enter the number before the dial tone can be heard, the call may
not be connected, or the wrong number may be dialed.
■
