1
2
3
4
5
6
7
8
9
10
11
Back
Next
Previous
TOP
10-42
Before Using the
Machine
Document and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network
Remote UI
System Manager
Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Cannot receive using Error Correction Mode (ECM).
Does the sender’s machine support ECM?
If the sender’s machine does not support ECM, the
document is received in normal mode without error
checking.
Receiving of documents is too slow.
Is ECM (Error Correction Mode) set to <ON>?
Because ECM corrects errors during a transmission,
any problems on the line can mean that the
transmission will take extra time. Set <ECM RX> to
<OFF>. (See “TX/RX SETTINGS,” on p. 11-11.)
Is the resolution of the sender’s machine set
higher?
Contact to the sender and make sure the resolution of
the sender’s machine has been set properly.
Q
A
Q
A
Q
A
You cannot get documents from information services.
Is your machine set to the tone dialing type of the
telephone line?
Press [Tone] to set the tone dialing.
Do you receive messages from the information
services such as to press [Start] after the beep to
receive?
When you hear the beep sound, press [Start].
Errors occur frequently while receiving.
Are the telephone lines in poor condition, or do
you have a bad connection?
Check if there is a device nearby that interferes with
signal reception (e.g., microwave oven).
Lower the reception speed. (See “SYSTEM SETTINGS,”
on p. 11-31.)
Q
A
Q
A
Q
A
A
