Dual Shot Mode
47
2 Touch the zoom controls to operate
the zoom.
Touch anywhere within the
Q
area to
zoom out or anywhere within the
P
area
to zoom in. Touch closer to the center for
a slow zoom; touch closer to the
e
/
d
icons for faster zooms.
3 Touch [
a
] to hide the zoom controls.
NOTES
• Keep at least 1 m (3.3 ft.) away from the subject. At full wide angle, you
can focus on a subject as close as 1 cm (0.39 in.).
• In
or
mode, you can also set
7
/
8
8
[Zoom Speed] to one of three constant speeds (3 is the fastest, 1 the
slowest).
• When [Zoom Speed] is set to [
I
Variable]:
- When you use the
P
and
Q
buttons on the wireless controller, the
zoom speed will be constant at [
J
Speed 3].
- The zoom speed will be faster in record pause mode than when
actually recording, except when pre-recording (
0
• See
Specifications
(
0
202) for notes about this function when the
recording program is set to [
r
Underwater] or [
s
Surface].
Quick Start Function
When you close the LCD panel with the camcorder on, the camcorder
enters the standby mode. In standby mode the camcorder consumes
only about 1/3 the power used when recording, saving energy when
you are using a battery pack. Additionally, when you open the LCD
panel, the camcorder is ready to start recording in approximately
1 second*, allowing you to record the subject right away.
* The actual time required varies depending on the shooting conditions.
1 With the camcorder on and in a recording mode, close the LCD
panel.
A beep will sound and the green ON/OFF (CHG) indicator will change
to orange to indicate the camcorder entered standby mode.
Operating modes:
Summary of Contents for 4353B001
Page 1: ...PUB DIE 0367 000 HD Camcorder Instruction Manual Y ...
Page 11: ...11 ...