117
Menu Settings
Advanced
Guid
e
Me
nu Setting
s
Other settings
> [System settings] >
[Other settings]
Lock operation with a password, set a password, reset counters for lamp or air filter
replacement, and access other settings and information.
Password settings
Disables the projector unless the correct password is entered.
Option
Function
Off
The projector can be used even if no password is entered.
On
The projector cannot be used unless you enter your password.
To Cancel the Password
Cancellation
on the
Projector
Turn off the projector and unplug the power plug.
Hold down the
MENU
button on the side control and connect the power
plug. Make sure to keep holding down the
MENU
button until a beep
sounds. When the projector beeps, the password is canceled. (The
entered password is also reset.)
Cancellation
on the Remote
Control
To forcibly cancel the password from the remote control, in standby state
press the
MENU
button 3 times, then press the
POWER
button.
• You cannot set [On] unless you have completed [Register password].
Once you set a password, the password entry screen appears at power-on.
Enter a 4 digit password.
Enter the password using the
[ ] / [ ] / [ ] / [ ]
buttons or number buttons on the
remote control.
If the password is valid, the projection starts. If you enter a wrong password three times,
the power will be turned off.
• The projector also goes off after 3 minutes of inactivity on the password input
screen.
