70
Chapter 5
User Modes
About the User Modes
You can configure the scanner settings with the user modes described below.
User Mode Functions
User mode functions are as follows:
●
Count Only Mode
ON: Count Only Mode (See “Using the Count Only Mode,” on p. 63.)
OFF: Normal Mode (default)
●
Long Document Mode
ON: Enables detection of documents up to 630 mm long for auto document
size detection. (See “Documents,” on p. 46.)
OFF: Enables detection of documents up to 432 mm long for auto document
size detection (default).
●
If you scan using Long Document Mode, the scanning speed may slow down.
●
If a document page is not aligned correctly when using the Long Document Mode, it
might come into contact with the two sides of the feeder, which can damage the
page. Take care to make sure that document pages are aligned correctly.
●
Stand-by Mode
ON: Scanner enters Stand-by Mode after 10 minutes of non-use (default).
OFF: Scanner does not enter Stand-by Mode.
●
Display Language Mode
ON: Japanese
OFF: English (default)
Note
