Canon
Booklet Maker Service Support Guide
B. Watkiss P2T 2-Knife Trimmer for Training Course
To service the optional Watkiss P2T 2-Knife Trimmer for the Booklet
Maker, service technicians must complete the Watkiss P2T 2-Knife Trimmer for
the comprehensive blended learning program. The online course
module, available on Canon USA’s
. The 3-day
Hardware classroom courses blends the information taught online with hands-
on, practical training in the classroom and lab.
The training for the Watkiss P2T 2-Knife Trimmer is a fee based course. To
order from Canon Network Access use item code 2115V542. The course fee is
$742.50.
Table 7 – Watkiss 2-Knife Trimmer Training Course
Course Name
Course Code
Watkiss P2T-2-knife Trimmer for eLearning Course
19DDSP2T500O
Watkiss P2T-2-knife Trimmer for Technical Training
19DDSP2T501C
Item Numbers and Part Numbers are subject to change without notice.
C. Prerequisites
Service
technicians must successfully complete the VarioPrint
6XX0Ultra/TP/MICR Training Program.
D. Certification
•
BLM 550+ Booklet Maker
Technician certification is required for authorization to sell these products and
to receive support.
E. Who Should Attend
It is highly recommended that any technician responsible for installing,
servicing, or supporting the BLM 550+ Booklet Maker complete the Training
Course.
Note:
Our current support policy dictates that only those technicians who have
completed the training program and pass the final assessment exam are
entitled to live, phone-based support through our TSC (Technical Support
Center). However, self-service support (software downloads, knowledgebase
articles, support forums, technical publications) is available through our
for all technicians. (Refer to the Technical Support
Booklet Maker Service Support Guide
March 2015
Revision 1
Page 6
