Canon
Booklet Maker Service Support Guide
D. Estimated Installation Times
The estimated Installation times below are the estimated times required for
installation of the Booklet Maker (including the connecting bridge)
starting from an unpacked condition. The estimated installation times can be
achieved only with a minimum of two (2) experienced technicians on the
Booklet Maker.
Actual work times may differ from the estimated times shown in the table below.
Table 13 – Estimated Installation Times
Description
Estimated Time
Booklet Maker (including the connecting bridge)
6.0 Hours
Book Stacker
2.5 Hours
Watkiss P2T 2-Knife Trimmer
3.0 Hours
E. Environmental Requirements
When installing the Booklet Maker and accessories, the
environmental conditions of the room where the machine is located should be
as described in the table below.
Table 14 – Optimal Environmental Conditions
Optimum Temperature Range
Between 50°F (10°C) and 95°F (35°C)
Optimum Humidity Range
Between 35% and 85% Relative Humidity
Atmospheric Pressure
(Storage and Transport)
up to 2,000m amsl
Noise (sound level)
Maximum: 87 dB
Notes:
•
In certain areas of the country and during certain times of the year, it may
be necessary to use a humidifier or dehumidifier to attain the proper
humidity levels for optimal machine performance. There is a risk that
productivity and paper feeding may be affected if the machine is operated
outside of these guidelines.
•
The machine should not be installed in locations with significant shifts in
temperature or humidity. Areas containing water, or equipment that can
significantly alter room temperature or humidity, such as a heater, stove, or
portable air conditioner, should be avoided, unless proper environmental
control is available to achieve maximum productivity or quality capability.
Booklet Maker Service Support Guide
March 2015
Revision 1
Page 13
