Canon
Booklet Maker Service Support Guide
B. Book Stacker
The optional Book Stacker has the following features:
•
Stacking capacity of up to 36.6” (930 mm). This is approximately:
•
400 booklets of 10 sheets/40 pages (2 mm thick spine)
•
175 booklets of 25 sheets/100 pages (5 mm thick spine)
•
80 booklets of 50 sheets/200 pages (10 mm thick spine)
•
Accepts books of different thicknesses and sizes without the need to unload
booklets until the stacker is full.
•
Supported book sizes:
•
Spine length: minimum 8.0” (203 mm), maximum 19.2” (320 mm)
•
Book width: minimum 3.15” (80 mm), maximum 9.6” (244 mm)
•
Book thickness: minimum 8 page booklet (dependent on media),
maximum 200 page booklet (10 mm)
Note: The BLM550 and BLM500 require an upgrade kit to connect Book
Stacker.
C. Watkiss P2T 2-Knife Trimmer
The optional 2-Knife Trimmer has the following features:
•
Adjustable top and bottom side trimming of booklets (up to 200 pages, 80
g/m
2
).
•
Trim up to 1.57” (40 mm) each from the top and bottom side of the booklet
(up to 3.15” (80 mm) total).
•
The operator can configure the trim position so that it can be offset from the
center-line to match the image position.
Note: The BLM550 and BLM500 require an upgrade kit to connect the Watkiss
P2T 2-Knife Trimmer.
Booklet Maker Service Support Guide
March 2015
Revision 1
Page 3
