10
FB1200S Getting Started
Start Windows
After you have installed the SCSI card, start the Windows program.
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
1
Turn on the computer.
▼
After a few moments, the New Hardware Found message will
display and the required software will automatically install.
Subsequently, a new message asking you to restart the computer
will display.
• The New Hardware Found message may not display if you are
replacing an already installed SCSI card with this card or your
Windows version is different. In this case, proceed to the section
entitled
Confirming the Status of the SCSI Card (p. 15)
.
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
2
Click the [No] button.
• Continue on to the next step to install the driver software without
restarting Windows.
▼
Windows will start for the first time.
• The standard Windows driver has been installed with the
previous steps. However, since the SCSI card may not operate
correctly with the standard Windows driver, it is necessary to
install the special driver contained on the CanoScan Setup
Utility CD-ROM. Install the correct SCSI driver following the
procedures in the section entitled Installing the SCSI Driver (p.
13).
• Messages may vary between Windows versions.
• If a message displays in Step 1 that requests the Windows
system disk, set it in the drive and click the [OK] button (use
the requested floppy disk if the Windows system is on floppies
or the CD-ROM if it is on a CD-ROM). Pressing the OK button
starts the automatic installation of the standard driver
software and starts Windows.
Macintosh
Windows
WARNING
