FB1200S Getting Started
13
Installing the SCSI Driver
After the SCSI card has been installed, you should install the SCSI
driver from the CanoScan Setup Utility CD-ROM onto the computer’s
hard disk. The SCSI driver software is required to operate the SCSI
card with your computer. Have the CanoScan Setup Utility CD-ROM
close at hand and follow the steps below.
• Windows 98
There is no need to install the SCSI driver provided on the CD-ROM.
Turn off the computer and proceed to the section entitled
Connecting
to the Computer (p. 16)
.
• Windows 95/NT 4.0
Install the SCSI driver with the following procedures.
• The driver software installed below is for exclusive use with
the Adaptec AIC-7850 PCI SCSI Controller card included in
your scanner package. If you are using another SCSI card,
please do not install this driver.
• Do not install the ScanGear CS-S program and the other
application software programs supplied on the CanoScan
Setup Utility CD-ROM until you have completed the
following steps.
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
1
Set the CanoScan Setup Utility CD-ROM into the
computer drive.
▼
Language select window will display to select your language, then the
following window will automatically display.
• If the menu window does not display, double-click the [My
Computer] icon on the Windows desktop, then the [Canoscan] icon
to start the CanoScan Setup Utility.
Menu Window
WARNING
Macintosh
Windows