2
2
2-4
2-4
Technology > Controls > Paper Size Detection Control
Technology > Controls > Paper Size Detection Control
Paper Size Detection Control
Paper size in a cassette is automatically detected by the "Cassette Size Switch". Paper size
in a cassette is automatically detected by adjusting the Guide Plate position.
By shifting the Guide Plate, concavo-convex area of the Cassette Size Dial is switched
and the Cassette Size Switch at the printer side is switched. The switch consists of 4
microswitches, and length and width are detected in accordance with the combination of
ON/OFF. As long as standard size paper, it can be used for both AB configuration and inch
configuration. However, distinction between A5-R and STMT-R and between EXEC-R and
16K-R should be specified manually on the check screen.
SW101
Length Detection
Size
Length
1
2
3
4
A5-R
210.0
-
-
ON
ON
STMT-R
215.9
-
-
ON
ON
B5-R
257.0
ON
-
-
-
EXEC-R
267.0
ON
ON
-
-
16K-R
270.0
ON
ON
-
-
LTR-R
279.4
-
ON
ON
-
A4-R
297.0
ON
-
ON
ON
LGL
355.6
-
-
ON
-
(No cassette)
-
-
-
-
-
In addition, presence of the cassette is detected when the size switch is pushed. (If no switch
is pushed, it is judged as no cassette.)
F-2-8
T-2-1
Rear Guide Plate
Cassette Size
Switch (SW101)
Rear
Detection
Rink
Setting method when the size detection patterns are overlapped
Method to distinguish between A5-R and STMT-R and between EXEC-R and 16K-R is
specified by the user settings.
Method to distinguish the special paper is specified by the user settings.
Setting sizes are as follows.
Related service mode
PRINT> CST> CASX> CSTX-UY> Setting number (Cassette paper size group special,
standard-size paper entry)
X indicates the cassette number, and Y indicates size category. (X, Y is one of the number
1/2/3/4.)
U sizes
Settings
U1
26: OFI, 37: M-OFI, 24: FLSP, 25: A-FLSP, 42
)$*/*/'HIDXOW
U2
32: G-LTR-R, 23: K-LGL-R, 0: Default
U3
0: Default
U4
28: B-OFI, 0: Default
F-2-9
T-2-2
Summary of Contents for Cassette Module-Y1
