CHAPTER 4 SERVICE MODE
4-102
INSTALL
COPIER>FUNCTION
Used at time of installation.
Level 3
SPLY-Y
SPLY-M
SPLY-C
SPLY-K
STIR-Y
STIR-M
STIR-C
STIR-K
STIR-4
INIT-Y
INIT-M
INIT-C
INIT-K
INIT-4
RECV-Y
RECV-M
RECV-C
RECV-K
Remarks
Description
Use it to rotate the developing cylinder to supply a
specific color developer to the developing assembly.
Using the Item
1) Select an item (to highlight), and press the OK
key.
2) To stop, press the Stop key.
Use it to stir the developer inside a specific color
developing assembly.
Using the Item
1) Select an item (to highlight), and press the OK
key.
2) The operation will stop automatically in about 2
min.
Use it to stir the developer in the four developing
assemblies in sequence.
1) Select the item (to highlight), and press the OK
key.
2) The operation will stop automatically in about 9
min.
Use it to read the initial value of a specific toner
concentration signal SGNL, REF.
·
The screen (COPIER>ADJUST>DENS) will
show the reading. Be sure to record it on the
service label.
Using the Item
1) Select the item (to highlight), and press the OK
key.
2) The operation will stop automatically in about 2
min.
Use it to read the initial value of the four color toner
concentration signals SGNL, REF in sequence.
·
The screen (COPIER>ADJUST>DENS) will
show the readings. Be sure to record them on the
service label.
Using the Item
1) Select the item (to highlight), and press the OK
key.
2) The operation will stop automatically in about 9
min.
Use it to rotate the developing cylinder, thereby
drawing the developer from a specific color
developing assembly.
Using the Item
1) Select an item (to highlight), and press the OK
key.
2) To stop, press the stop key.
Note:
You will use this mode during installation.