2
2
2-19
2-19
Functions > New Function > Fax Numbers
Functions > New Function > Fax Numbers
MEMO
The pause time differs in length, depending on whether it is entered in the middle or at
the end of a fax number.
The pause time entered in the middle of a fax number(lower-case p) is set to four seconds
long by default. This can be changed to any length between 1 and 15 seconds.
The pause time entered at the end of a fax number (upper-case P) is set to 10 seconds
long.(This length cannot be changed.)
Two or more pauses can be entered consecutively.
You can press (Clear) to clear your entry.
•
•
(3) Press [Option].
You can specify the following optional settings:
[Setting Speed]:.....Adjusts the transmission speed. Available speeds are '33600bps',
'14400bps', '9600bps', and '4800bps'. If your document transmissions are slow in starting,
this may mean that the telephone lines in your area are slow. Select a slower speed.
The default setting is '33600bps'.
[Long Distance]:.....Specifies long distance settings. Available settings are 'Domestic', 'Long
Distance(1)', 'Long Distance(2)', and 'Long Distance(3)'. Use 'Domestic' for dialing domestic
(local) telephone numbers. Use 'Long Distance(1)' if communication errors frequently occur
•
•
F-2-9
F-2-9
when you make overseas calls (when the overseas telephone number is registered in the
Address Book). If errors persist, try using 'Long Distance(2)' or 'Long Distance(3)'.
The default setting is 'Domestic'.
[ECM TX]:.....Sends documents with ECM (Error Correction Mode). ECM reduces the
effect of system and line errors on documents that may occur when sending or receiving
with another fax machine that supports ECM. If the other machine does not support ECM,
this setting is ignored. Even when ECM is set, errors can sometimes occur due to a poor
telephone line connection. If there is trouble with the line, it will take more time to send
the documents. So transmission speed appears to be extremely slow, you may be able to
speed up the transmission time by turning ECM 'Off'.
The default setting is 'On'.
If you want to specify [Sending Speed]:
Press [Sending Speed].
•
●
F-2-10
F-2-10
