4
4
4-6
4-6
Functions > Related Service Mode > Invalidating Transfer of a License
Functions > Related Service Mode > Invalidating Transfer of a License
Invalidating Transfer of a License
Invalidating Transfer of a License
Situation where this service mode is used
This service mode is used to invalidate a license under the assumption that, when a device is
exceptionally replaced with another one due to a trouble (caused by the device), the license
is transferred to another device. This operation is called "invalidating transfer of a license".
Since it is possible to select the same device as a destination of the transfer, this service
mode can be also used to invalidate a function on a temporary basis. Careful attention,
however, is required because, if you invalidate a function by mistake, you need to contact a
sales company for recovery.
Procedure to invalidate transfer
When invalidating transfer of a license, it is necessary to invalidate the license by entering the
service mode and issue a function invalidation certificate key, which certifies that the license
has been invalidated. This operation can be executed for each optional function. At the point
when a function invalidation certificate key is issued, the function is invalidated and becomes
unavailable. When you report this function invalidation certificate key, the serial number of
the transfer origination device, the serial number of the transfer destination device, and the
reason why you need to perform the transfer to a sales company, a new license key is issued
for installation for the transfer destination device. Be sure to write down the new license key
when you receive it and, when it is registered in the transfer destination device successfully,
inform the user of the new license key and explain him/her to keep it at hand.
Operation Procedure
(1) Enter the service mode and display the following service mode. (Press one key at once to
enter the service mode in the order of "Main, 2, 8, Main".)
When you have entered the service mode, use the left and right arrow keys to display items,
and press the OK key to fix the setting.
(2) Display [#LMS].
(3) Press the OK key and display [#LMS INACTIVE].
(4) Press the OK key and display [ST-SEND].
(5) Press the OK key.
(6) Press 0 using the numeric key and press the OK key.
(7) Go back and display [TR-SEND].
(8) Press the OK key.
(9) The 24 digits of license transfer numbers are displayed, so you take the memo.
Because it cannot maintain the number displaying with the thing of this place limit.
If you do not take the memo, the indication contents are not held when you do OFF of
the main power, it is impossible for license transfer.
Even if you push the reset key and clear the indication, the indication is never display
again.
License transfer numbers:
F-4-3
F-4-3
