COPYRIGHT© 2000 CANON INC.
2000 2000 2000
ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 5 TROUBLESHOOTING
5-9
T05-202-01ColorPASS beep codes
Memo
Some beep codes continue to loop until the ColorPASS is powered off and
the error is corrected.
B
eep code
Area reporting
the error
1 long beep—Pause—short beeps
Battery
5 short beeps—Pause—1 long beep
DIMMs
6 short beeps—Pause—1 long beep
8 short beeps—Pause—1 long beep
CMOS settings
9 short beeps—pause—1 long beep
DIMMs
10 short beeps —Pause—1 long beep
11 short beeps—Pause—1 long beep
Suggested action
• Replace the battery on the motherboard.
• Make sure you reset the time and date in
Setup after replacing the battery.
• Make sure all DIMMs installed on the
motherboard are Canon approved with
part number 45005190.
• Reseat all DIMMs in their sockets and
restart the ColorPASS in order to run the
startup diagnostics.
• If the error persists, replace each DIMM
one at a time with a good DIMM until you
locate the faulty DIMM(s).
• If the above does not correct the error, you
may need to replace the motherboard.
• Reboot the ColorPASS.
• If the problem persists, replace the battery
on the motherboard.
• If the problem still persists, you may need
to replace the motherboard.
NOTE: If you replace the battery, reset the
time and date in Setup after replacing the
battery.
• Make sure all DIMMs installed on the
motherboard are Canon approved
(DIMMS should be Canon part number
45005190).
• Reseat all DIMMs in their sockets and
restart the ColorPASS in order to run the
startup diagnostics.
• If the error persists, replace each DIMM
one at a time with a good DIMM until you
locate the faulty DIMM(s).
• If the above does not correct the error, you
may need to replace the motherboard.