Assemble Fin-b, and attach it to B02.
Assemble Fin-l and Fin-r,
and attach them to B01.
After attaching B01 and B02, attach the parts marked
in the green lines on B01 and B02 to close the body.
Then, attach by following the correct order
(refer to the green numbers).
Use a stick for areas where you cannot use your fingers.
Attach and assemble everything
except for the part marked in the
green line on B01 and attach to B02.
Assemble B02.
*There is no specific order for attaching glue tabs
without green attachment order numbers. However,
only attach them one at a time from either end
and not all at once.
curl
Attachment order.
glue
Glue tabs have been omitted from the diagrams to make them easier to understand.
PAGE02
Bottlenose Dolphin : Assembly Instructions
