15
D1250U2F Quick Start Guide
Scanning Film
Preparation
Removing the Protective Sheet
The document cover is equipped with a protective sheet for the
light source. Make sure to remove this sheet before scanning
film.
Remove the protective sheet by sliding it in the direction of the
arrow.
• Keep the protective sheet carefully not to be bent nor torn.
• Replace the protective sheet over the light source when not scanning film.
Positioning the Film
Load a film into the film guide as shown below and place the loaded guide onto the scanner’s
document glass.
1.
Insert a fingernail into the slot in the film guide
and lift up the flap.
2.
Place the film face down into the groove in the
film guide.
Position the target frame of the film in the middle of
the groove.
• Hold the film by the edges with your fingertips to avoid getting fingerprints or dirt on
the film surface.
• Any dust on the film, scanner document glass or light source will show in the scanned
images. Remove dust with a blower brush.
Light Source
Flap
*D1250U2F_QSG_E
11/24/01, 7:19 AM
15
