CHAPTER 3 MECHANICAL SYSTEM
3-6
COPYRIGHT © 1998 CANON INC. CANON DADF-A1 REV.0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
II. DRIVE SYSTEM
A. Removing the Pick-Up
Motor Unit
1) Remove the body cover.
2) Remove the tie-wrap as necessary.
3) Disconnect the connector J12 [2] from the
DADF controller PBC [1].
[1]
[2]
Figure 3-201
4) Remove the screw [3], and remove the
cable guide [4].
[3]
[4]
Figure 3-202
5) Disconnect the connector [5] of the upper
cover sensor S4.
6) Remove the two mounting screws [6], and
detach the pick-up motor unit [7].
[6]
[6]
[5]
[7]
Figure 3-203
B. Removing the Feeder Motor
Unit
1) Remove the pick-up motor unit.
2) Remove the tie-wrap as necessary.
3) Disconnect the connector J11 [2] from the
DADF controller PCB [1].
[1]
[2]
Figure 3-204
