101
SNMP Setting
If you click [SNMP Setting] on the Device Configuration screen, the
page below is displayed.
Item
Description
Default Value
mDNS
Enable/disable multicast DNS.
This setting allows scanning
applications to search for and
automatically connect to the
scanner.
This is normally enabled.
When the setting is disabled, you
must manually specify the scanner
using its assigned IP address to
scan from the scanning
application.
ON
Item
Description
Default Value
SNMP
Service
Sets the SNMP function to
enabled/disabled.
OFF
Location
Input the location where the
scanner is installed.
None
Security -
Auth trap
Sets the SNMP authentication trap
function to enabled/disabled. By
setting this to [ON], if an SNMP
request is received from a
community that is not registered in
[Community Setting], then a
message is sent to the trap
destination.
OFF
SNMP v1
Sets the SNMP v1 support function
to enabled/disabled.
OFF
Community
Setting
Moves to the [Community Setting]
screen.
-
SNMP v3
Sets the SNMP v3 support function
to enabled/disabled.
OFF
User Setting
Moves to the [User Setting] screen. -