95
E
Editing
Audio Dubbing
OUTPUT
AUDIO
L
R
You can add sound to the original sound on a pre-recorded tape from audio
products (AUDIO IN) or with the internal or external microphone (MIC. IN). The
original sound will not be erased. For best results, add sound to tapes that have
been recorded with this camcorder in SP mode with 12-bit sound. If there are
non-recorded portions on the tape, or portions recorded in a mode other than SP
mode, or with 16-bit or 12-bit, 4-channel sound, dubbing will stop. If your tape
hasn’t been recorded in SP mode with 12-bit sound, we recommend dubbing your
original tape onto a blank tape using the ELURA50’s analog line-in function, then
dubbing audio onto the new tape. Make absolutely sure to set the audio mode of
the new tape to 12-bit and the recording mode to SP.
To connect other audio equipment:
Notes:
• Do not use the yellow video terminal.
• The AV terminal doesn’t put out any video, so connect the S-video terminals
and check your TV, or check the LCD or the viewfinder as you add new sound.
Always check the new sound with the speaker.
To connect an external microphone:
STV-250N
Stereo Video Cable
An audio device
(i. e. CD player)
: Signal flow
Summary of Contents for ELURA 50
Page 173: ......
