412
If a problem occurs with the camera, first consult this Troubleshooting
Guide. If this Troubleshooting Guide does not resolve the problem,
contact your dealer or nearest Canon Service Center.
Do not use any battery other than genuine Canon Battery Pack
LP-E17.
If (1) the battery charger or battery has a problem or (2)
communication with the battery failed (with a non-Canon battery pack),
the protection circuit will stop charging, and the charge lamp will blink
in orange. In the case of (1), unplug the charger’s power plug from the
power outlet. Detach and reattach the battery to the charger. Wait two
or three minutes, then reconnect the power plug to the power outlet. If
the problem persists, contact your dealer or nearest Canon Service
Center.
Make sure the battery is installed properly in the camera (p.38).
Make sure the card slot/battery compartment cover is closed (p.38).
Recharge the battery (p.36).
Press the <
U
> button (p.70).
If the power is turned off while an image is being recorded to the card,
the access lamp will remain on or continue to blink for a few seconds.
When the image recording is complete, the power will turn off
automatically.
Troubleshooting Guide
Power-Related Problems
The battery does not recharge.
The battery charger’s lamp blinks.
The camera is not activated even when
the power switch is set to <
1
>.
The access lamp still blinks even when
the power switch is <
2
>.
