Chapter 2
Setting Up
2-15
Setting Up
Loading Paper
This section describes how to load plain paper in the multi-purpose tray so that you can
begin using your copier/fax.
For more details on paper requirements and selecting paper, see Chapter 5, Paper
Handling.
Paper Guidelines
• Use cut-sheet paper only, not paper that comes on a roll.
• Do not use paper thicker than can be used for the copier/fax unit (
1
p. 5-2). Thick
paper can come into contact with the print head nozzles and cause damage to the BJ
cartridge.
• Do not load paper beyond the paper limit mark (
P
) or beyond the tab on the multi-
purpose tray. Doing so may cause paper feeding or printing problems. Also, make
sure there are no gaps on either side of the paper stack.
• If the paper has a print side, set it in the multi-purpose tray with the print side facing
upward.
• The capacity of the output tray is 50 sheets of paper. To prevent paper jams, remove
paper from the output tray before the count reaches 50.
• Let the paper run out before refilling the multi-purpose tray. Avoid mixing “new” paper
with paper already loaded.
• Do not leave paper stacked in the multi-purpose tray for long periods of time since it
may bend or curl over time, and cause paper jams or misfeeding problems.
• Certain environmental conditions, such as extreme temperatures or humidity, can
cause some paper to misfeed in the multi-purpose tray. If you have trouble with paper
becoming skewed or multiple sheets being fed, do not stack them in the multi-purpose
tray, but feed them one sheet at a time.
PAPER LIMIT MARK
NO GAPS HERE
TAB
Summary of Contents for FAXPHONE B740
