COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
4-11
CHAPTER 4 MECHANICAL CONSTRUCTION
2.2 Swing Unit Inlet Guide and the Buffer
Base Plate
After releasing the buffer unit, fit the swing
guide to the frame, being careful so that the
swing unit inlet guide edge 1 will not ride over
the buffer base plate 2.
Figure 4-207A
2.3 Shutter Bar Position
The shutter bar 1 of the swing guide must
be in bottom position (Figure 2-4). It must not
be in top position (Figure 2-5); otherwise, the
shutter link of the lattice guide (lower) and the
shutter bar will not engage correctly later.
To ensure that the shutter bar will be in bot-
tom position, correct the position before fitting
the swing guide to the frame. To do so, turn the
one-way cam 3 found at the end of the feeding
roller 2 in the direction of the arrow until it stops.
[2]
[1]
Figure 4-208A
[1]
Figure 4-209A
Figure 4-210A
[1]
[2]
[3]
