COPYRIGHT © 1996 CANON INC. CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
4–20
4. MECHANICAL SYSTEM
B. Multifeeder Assembly
1. Removing the Multifeeder Unit
1) Open the multifeeder assembly
q
, and insert
a large flat-blade screwdriver into the top
w
of
the connector cover, and turn it to remove the
cover; then, disconnect the connector.
Figure 4-407
2) Close the multifeeder assembly, and open the
right door; then, pull out the rolls
e
from the
left and the right.
Figure 4-408
3) Remove the multifeeder assembly.
Reference:
When installing the multifeeder connector
cover, match the top first and push the bot-
tom in.
2. Removing the Multifeeder Pick-Up
Roller
1) Pull out the multifeeder rolls.
2) Detach the cable from the cable, and remove
the right door
q
.
Figure 4-409
3) Remove the snap-on bushing
w
, and shift the
roller shaft
e
in the direction of the arrow.
4) Remove the stop ring
r
, and remove the mul-
tifeeder pick-up roller
t
.
Caution:
Work carefully while paying attention to the
pin at the rear of the pick-up roller.
Figure 4-410
5
4
3
2
1
3
3
2
1
