DR-2010C / DR-2510C
DR-2010C / DR-2510C
43
- [Skip Blank Page]
As each document page is scanned, the scanner detects whether it is blank,
and if so, the image is not saved.
y
Selecting [Skip Blank Page] enables the [Setting] button, which opens the
[Blank Skip Setting] dialog box.
y
Adjust the [Content density] setting in the [Blank Skip Setting] dialog box if
blank pages are not skipped, or if non-blank pages are skipped.
y
The [Content density] setting should be adjusted according to the
document content, so that only blank pages are skipped: increase the
setting if they are not skipped, and decrease the setting if non-blank pages
are skipped.
y
The Skip Blank Pages function may not work properly if the [Custom]
setting is enabled in the [Gamma Settings] dialog box.
y
If a scanning side setting (simplex or duplex) is specified in the application
settings, set [Simplex].
- [Folio]
Documents that are normally folded in half are scanned on both sides and
composed into one image.
y
You cannot click [Folio] if you click [Patchcode] in the [Batch Separation]
box of the [Others] tab.
This section describes the procedure for setting the scanner to detect slanted
document pages and straighten the scanned images.
1
In the ISIS/TWAIN driver properties dialog box, click the [Basic] tab
→
select the [Deskew] check box.
NOTE
Deskewing SWITCH also may not work properly or cause part of the image to be
lost in other cases, depending on the document.
Correcting Image Skewing
