Chapter 2
Setup
2-12
3
Connect the power cord into an AC outlet.
b
4
Use the supplied USB cable to connect the scanner to the computer.
Using a SCSI Connection
IMPORTANT
• Make sure that the computer is turned OFF before connecting the SCSI cable. If the cable is
connected while the computer is on, the scanner may not be properly recognized by the
computer.
• A SCSI cable is not supplied with the scanner. Purchase a cable that is suitable for the
scanner and for the SCSI connector on the computer.
• The SCSI ID of the scanner is set to “SCSI ID = 2” by default. When using a daisy-chain
configuration with other SCSI devices, set the DIP switches so that there is no duplication of
SCSI ID numbers in the system.
• The DR-6010C scanner incorporates a SCSI terminator which is permanently set to ON.
When using a daisy-chain configuration with other SCSI devices, make sure that the DR-
6010C is connected as the last device in the chain. Set the terminators of all other devices
to OFF.
Type A
Type B
symbol on plug should face down
DIP switches
Factory default (SCSI ID = 2)
Summary of Contents for IMAGE FORMULA DR-6010C
Page 5: ...User Manual Hardware...
Page 94: ...User Manual Software...