NetBIOS Network Setup Procedures
5-2
5
Usi
ng a NetBIOS Netw
o
rk
NetBIOS Network Setup Procedures
To use a NetBIOS network, it is necessary to perform the following procedures.
1
Protocol Settings (See "Protocol Settings," on p. 5-3.)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
The Remote UI (via a web browser)
2
Computer Settings for Printing/Sending a Fax (See "Setting Up a Computer for Printing/
Sending a Fax," on p. 5-6.)
Specify the settings of each computer you use for printing or sending a fax. (Optional equipment is required to
print or send a fax from a computer. For the equipment needed, see "Optional Equipment and System
Requirements," on p. 1-2.)
3
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p. 5-11.)
Specify the settings of the computer receiving data sent from the machine. (Optional equipment is required to
send data. For the equipment needed, see "Optional Equipment and System Requirements," on p. 1-2.)
IMPORTANT
•
It is recommended that steps 1 and 3 above be performed by the network administrator.
•
The only base protocol supported by a NetBIOS network is TCP/IP. (SMB is used as the
print application.) NetBEUI is not supported with the machine.
Summary of Contents for image RUNNER 3045
