8
Preparation Before Use
This chapter describes how to prepare the scanner to scan
documents.
Setting Up the Scanner
Perform the following steps to set up the CR-190i. Refer to the section
for each step for details about that step.
1
Check your operating environment. (See “Checking Your
Operating Environment” on p. 9.)
2
Install the software. (See “Installing the Scanning Utility”
on p. 9.)
Install the Scanning Utility provided with the CR-190i.
3
Connect the scanner to a computer. (See “Connecting the
Scanner to a Computer” on p. 10.)
4
Turn ON the power. (See “Turning ON the Power” on
p. 11.)
5
Automatically installing the device driver. (See p. 12.)
The device driver is installed automatically when Windows
recognizes the CR-190i.
IMPORTANT
• To have the device drivers installed automatically when the
computer recognizes the CR-190i, the software needs to be
installed before the CR-190i is connected to the computer.
• If you connect the computer and turn ON the CR-190i before
installing the software, the following wizard screen appears. If this
happens, click [Cancel], turn OFF the CR-190i, and then install the
software.
The following wizard screen is an example in Windows Vista. When
a similar wizard screen appears in Windows XP/7, click [Cancel].
Wizard Screen (Windows Vista)
