4
Preparation Before Use
This chapter describes how to prepare the scanner to scan documents.
Perform the following steps to set up the CR-L1. Refer to the section for each
step for details about that step.
A
Check your operating environment. (See “Checking Your
Operating Environment,” on p. 5.)
B
Install the software. (See “Installing the Software,” on p. 5.)
Install the Scanning Utility provided with the CR-L1.
C
Connect the scanner to a computer. (See “Connecting the
Scanner to a Computer,” on p. 6.)
D
Turn ON the power. (See “Turning ON the Power,” on p. 7.)
E
Automatically installing the device driver. (See p. 7.)
The device driver is installed automatically when Windows recognizes the
CR-L1.
IMPORTANT
•
To have the device drivers installed automatically when the computer recognizes
the CR-L1, the software needs to be installed before the CR-L1 is connected to the
computer.
•
If you connect the computer and turn ON the CR-L1 before installing the software,
the following wizard screen appears. If this happens, click [Cancel], turn OFF the
CR-L1, and then install the software.
The following wizard screen is an example in Windows 7. When a similar wizard
screen appears in Windows 8.1/10, click [Cancel].
Setting Up the Scanner
Wizard Screen (Windows 7)
