19
3
Connect the plug of the AC adapter to the power connector on the back of
the scanner.
4
Use the supplied USB cable to connect the scanner to the computer.
3. Turning the Power ON
When you turn the computer and the scanner ON for the first time, the Plug and
Play function of Windows recognizes the scanner and automatically installs the
required device driver.
IMPORTANT
•
If you turn the power OFF, wait at least 10 seconds before turning it ON
again.
•
If you will not be using the scanner for an extended period, you should
disconnect the power cord from the AC outlet for safety.
The scanner will be recognized the first time it is connected to the computer.
1
Make sure that the scanner and computer are connected properly.
2
Press the power switch on the back of the scanner to turn the scanner ON
(I side).
Scanner Recognition
