CHAPTER 5 TROUBLESHOOTING
set the value using the arrow keys
on the computer.
With performing automatic registration
adjustment
2) Place the scale parameter adjustment
sheet and display the screen. For details,
refer to the “Scale Parameter
Adjustment” section.
This section gives the procedures for
performing automatic registration
adjustment in this mode.
1) Click the [Reset] button. All of the values
change to zero. (Refer to Figure 5-238)
3) Execute manual registration adjustment if
required. For details, refer to the “Manual
Registration Adjustment” section.
2)
Execute automatic registration
adjustment. For details, refer to the
“Automatic Registration Adjustment”
section.
4) Check the trailing edge of the image and
set the scale parameter adjustment
values. Note that these are the [Factory
Scale Parameter] values. For more
details, refer to the “Scale Parameter
Adjustment” section.
3) Next, perform the procedure from Step 2
in the previous section “Without
performing automatic registration
adjustment “.
Note:
Note that if the roller friction is
severe, the adjustment may not be
possible with [Factory Scale
Parameter] alone. In this case, you
should also use [User Scale
Parameter], or replace the roller.
Figure 5-238
Figure 5-237
5-18
COPYRIGHT
©
CANON ELECTRONICS INC. 2011 CANON DR-C125 FIRST EDITION
