COPYRIGHT
©
CANON ELECTRONICS INC. 2011 CANON DR-C125 FIRST EDITION
5-19
CHAPTER 5 TROUBLESHOOTING
The following flow chart shows an
overview of the whole procedure when
performing automatic and manual
registration adjustment. Refer to the
each items for details.
Figure 5-239
11. Firm Load
Firmware is changed in this mode. For
details, refer to service information
provided when firmware is changed. Do
not use this mode by mistake.
Operation Procedure
1) On the service screen, select [Firm
Load].
2) The screen is displayed requiring the file
in which software is stored to be
selected.
3) Select and open the file.
4) It is loaded automatically and a progress
screen is displayed.
Figure 5-240
5) When the load is finished, the progress
screen disappears and the service
screen returns. The cumulative number
of sheets displayed at the bottom of the
service screen is “0: zero”.
Figure 5-241
Run automatic registration adjustment
Set scale parameter adjustment sheet
Run manual registration adjustment
Set [Factory Scale Parameter]
Select [Reset] button
Run scanning
Check the leading edge image
Run scanning again
Check the trailing edge image
Run scanning again
Check the final image
