CHAPTER 3 DISASSEMBLY & REASSEMBLY
I. EXTERNAL
PARTS
1. Left Cover
1) Insert a tool with a thin flat end into the 6
pairs of fitting parts
{
1
(2 each on the
front, rear and bottom marked with a
symbol) in sequence to spread open the
gap, and then remove the left cover
{
2
.
Note:
Take care to avoid scratching the
cover with the tool. You should
unhook the rear and bottom fitting
parts first.
Figure 3-101
Note:
Once you have removed the left cover,
the cable cover
{
1
and front unit
{
2
can be removed. Take care to avoid
accidentally dropping or damaging it.
Figure 3-102
Notes on assembling
Attach the cable cover so that the cable
would not be caught in parts. Then
insert the cable through the cut-out
{
1
in the left cover and attach the cover.
There should not be any gaps.
Figure 3-103
COPYRIGHT
©
CANON ELECTRONICS INC. 2011 CANON DR-C125 FIRST EDITION
3-1
