CHAPTER 3 DISASSEMBLY & REASSEMBLY
3. Rear Cover
4. Document Feed Tray
1) Remove the right and left covers.
1) Remove the right and left covers.
2) Remove the document feed tray and
upper cover assembly.
2) Unhook the protrusion from the groove
{
1
on both sides, and remove the
document feed tray and upper cover
assembly
{
2
.
Note:
Refer to “3. Rear Cover”.
3) Tilt the document feed tray
{
1
(with
document guides), unhook one side of
the fitting part
{
2
, and then remove the
document feed tray.
Figure 3-106
3) Use a tool to unhook the 4 pairs of fitting
parts
{
1
(2 each on the upper plate) and
remove the rear cover
{
2
.
Figure 3-108
4) Bend the document feed tray
{
1
(with
attached extension plates) and cover
{
2
to unhook the fitting part
{
3
inside, and
then slide in the direction of the arrow to
separate.
Figure 3-109
Notes on assembling
Ensure that the document feed tray (with
document guides) is attached in a correct
way.
Figure 3-107
COPYRIGHT
©
CANON ELECTRONICS INC. 2011 CANON DR-C125 FIRST EDITION
3-3
