5-19
Chapter 5 Maintenance
1.
Roughly align the right edge of the lock lever with the
desired printing position.
Hint
The position of the right edge of the lock lever indicates the
current printing position.
2.
Finely adjust the carriage position by moving it left or
right, then make sure you can feel it click in.
Hint
• If you do not feel it click in, the carriage is not aligned correctly
with a positioning hole. Always move the carriage to a position
where it clicks in.
• The imprinter cover will not close unless the carriage is
correctly aligned with a positioning hole. If it will not close,
check the position of the carriage.
Cleaning the Imprinter
■
Cleaning the Guide Plate
Ink that collects on the guide plate inside the optional
imprinter may stain the documents when they are scanned.
Clean off the ink with water and a mild detergent on a soft
cloth that has been firmly wrung-out, and then thoroughly dry
it with a dry cloth.
■
Cleaning the Ink Cartridges
If the imprinter print head nozzles are dirty, printing may
become streaked or spotty. To prevent this, periodically
remove the ink cartridge and clean the print head with a soft,
dry cloth or cotton swab.
Positioning Holes
(15 Locations)
Guide Plate
