3-23
Chapter 3 Basic Operation
4.
Close the upper unit gently. Then press it at both
ends to make sure it is fully closed.
(See “Closing the Upper Unit” on p. 5-3)
5.
Check to verify the last saved image, and perform
rescanning.
IMPORTANT
• Even if a document is ejected onto the eject tray, the scanned
image of the document may not be saved. Before rescanning,
always check the last saved image.
• Before rescanning, straighten documents that were detected
as skewed.
• Before rescanning, remove any staples that were detected in
documents.
Place the document removed from inside the scanner in
front of the other documents in the feed tray, and press the
Start key to resume scanning.
Handling a Double Feed
When a double feed is detected while scanning, the document
pages for which double feeding was detected are ejected at the
eject outlet, an error message appears on the Control Panel
display, and feeding stops.
IMPORTANT
When a double feed is detected, the following process occurs, and
messages appear according to the Rapid Recovery System setting
in the ISIS/TWAIN driver.
(See “[Rapid Recovery System] Check Box” on p. 8-6.)
■
When the Rapid Recovery System is Disabled
• When the Rapid Recovery System is disabled, images scanned
before the double feed are saved as files, scanning finishes, and
the following error message is displayed.
When detecting double feeds by document length
Start Key
