3-7
Chapter 3 Basic Operation
Gently open the extension wire.
Hint
Use the extension wire if the document beyond the edge of the
document tray extension.
Adjusting the Document Guides
The document guides normally extend at equal distances to
the left and right ends from the center of the feeder so that
documents are by default to be placed at the center of the
feeder inlet.
However, each document guide has its own lock lever, so you
can place documents either toward the left or right side of the
feeder inlet by locking the document guides at the appropriate
positions.
■
Loading Documents at the Left Side
This example shows the procedure for loading documents
at the left side of the feeder.
1.
Spread the document guides all the way to the left
and right.
2.
Load your documents against the left feed guide.
3.
Lock the left document guide (1) by pulling out the
lock lever, then slide the right document guide to the
right edge of your documents (2).
(2)
(1)
