35
Basic Operation
Documents
This scanner can scan documents ranging in size from business cards
and checks up to A3 size, and documents of the following sizes and
paper thicknesses can be used depending on the paper feed method.
Size
Width:
50.8 to 305 mm (2" to 12.01")
Length:
70 to 432 mm (2.76" to 17.01")
(when Long Document Mode is [Standard (432 mm)])
70 to 1,000 mm (2.76" to 39.37")
(when Long Document Mode is [Long Document (1000 mm)])
70 to 3,000 mm (2.76" to 118.11")
(when Long Document Mode is [Long Document (3000 mm)])
70 to 5,588 mm (2.76" to 220")
(when Long Document Mode is [Long Document (5588 mm)])
Hint
• Setting the scanner to Long Document Mode enables scanning
documents up to 5,588 mm (220") long.
• The [Long Document (5588 mm)] setting is not available in the
DR-G2090.
Paper thickness
Continuous Feeding:
20 g/m
2
to 209 g/m
2
(5 to 56 lb bond) (0.04 mm to 0.25 mm)
Manual Feeding:
20 g/m
2
to 255g/m
2
(5 lb to 64 lb bond) (0.04 mm to 0.3 mm)
Hint
Continuous feeding feeds document pages from the Document
Feed Tray one by one by the feed and retard rollers until the
batch of documents has been scanned.
IMPORTANT
The documents to be scanned must satisfy certain criteria. Read the
following items carefully.
• When scanning multiple pages, they must be grouped together so
that they have the same size, thickness, and weight. Scanning
different types of paper at one time may cause paper jams.
• Scanning documents before the ink is dry can cause problems with
the scanner. Always make sure that the ink on a document is dry
before scanning it.
• Scanning documents that are written in pencil or similar material
may make the rollers and scanning glass dirty, which can lead to
smudges on the scanned image and transfer the dirt to subsequent
documents. Always clean the internal parts of the scanner after
scanning such documents.
• When scanning a two-sided document that is printed on thin paper,
the image on the opposite side of each page may show through. In
that case, adjust the scanning brightness from the application
program, or enable the [Prevent Bleed Through/Remove
Background] setting before scanning.
