30
4
Open the page of the passport that you want to scan.
Insert the passport into the carrier sheet so that the
thicker side is positioned as close as possible to the
sealed end.
5
Load the document with the sealed end of the carrier
sheet as the leading edge and the page you want to scan
facing down.
After placing the document, align the document guides with both
edges of the document.
CAUTION
If the carrier sheet or passport is not loaded properly, you may
get a document jam or not get a scan image as intended.
IMPORTANT
• Depending on the condition of the carrier sheet or passport, the
image may not be scanned completely or the scanner's image
correction may not function properly. If this is the case, set [Page
Size] to a larger paper size (A4, for example) on the scanner
driver settings screen, and then scan again.
• If the size of the passport differs greatly from the size of the
carrier sheet, a document jam may occur or the scanner's
image correction may not function properly.
• The maximum thickness that can be scanned is
6
mm (0.24")
with the passport inserted inside the carrier sheet. If the
thickness exceeds
6
mm (0.24"), the scanner may break down
due to problems such as paper jam.
• Documents other than passports should not be inserted into the
carrier sheet and scanned. This may cause the scanner to
break down.
Placing Cards
When scanning cards, place one card at a time horizontally.
1
Opens the scanner driver's Detail Settings screen.
2
Open the [Feeding] Tab.
3
In [Document type], select [Extra-thick paper/Plastic
card].
4
Adjust the document guides to fit the width of the card to
be scanned.
