3
STEP 7
Selecting the Connection Mode
Tap the connection mode you want to use.
Connect via Wi-Fi
Connect with Ethernet cable
Connect with USB cable
Select a connection mode.
When using USB or wired LAN connection,
the home screen is displayed.
Shared Folder
Settings
CaptureOnTouch
Home
Shared Folder
Settings
CaptureOnTouch
Home
This completes setup.
When using Wi-Fi
connection, proceed to
connection settings.
Connecting via
Wi-Fi
Use the Wireless Connection Tool to automatically acquire the required network information from the
wireless settings of the computer connected to the access point, and connect the device to the same
network.
IMPORTANT
• If the access point is using security settings (such as MAC address filtering), change the settings to allow
connection to this device.
• To ensure good Wi-Fi communications, perform this procedure with the scanner located close to the access point.
• Connect the computer to the access point via Wi-Fi before you begin.
• Set the IP address of the computer to be obtained automatically. Wireless Connection Tool cannot be used if there
is no DHCP server on the network or if the computer does not have a wireless LAN function. In such cases, use
a different tool to connect the scanner. For other connection methods, refer to User Manual stored in the supplied
Setup Disc.
• The Wi-Fi function of the scanner is not guaranteed to work with all access points.
1.
On the computer, click the Start button
- [Wireless Connection Tool] - [Wireless
Connection Tool].
Wireless Connection Tool starts.
Hint
• In Windows 8.1, it is registered at the following
location.
2.
Select [DR-S150], and then click [Start].
3.
Operate the scanner touch panel following
the on-screen instructions, and then click
[Next].
4.
Select the scanner you want to set up, and
then click [Next].
5.
Select [Setup by using the computer’s
wireless settings], and click [Next].
6.
Click [Finish].
Check the icon in the top right corner of the
scanner touch panel.
Shared Folder
Settings
CaptureOnTouch
Home
Connected via Wi-Fi
Failed to connect via Wi-Fi
Hint
• If you cannot connect properly, refer to
“Common Problems and Solutions” in User
Manual stored in the supplied Setup Disc.
This completes setup.
6T3-0057-02.indb 3
2019/10/23 10:13:40
