3-8
COPYRIGHT © CANON ELECTRONICS INC. 2012
CANON P-208 FIRST EDITION
CHAPTER 3 DISASSEMBLY & REASSEMBLY
Notes on assembling
1) First, assemble the top cover (base)
{
2
so
that it goes under the fitting parts
{
1
of the
top cover and secure it with two screws
{
3
(self-tapping, BH M2.5x6). Then install the
spring in the hole
{
4
in the top cover B.
Figure 3-214
2) Assemble the follower roller (with a bear-
ing) and the one-way clutch.
Figure 3-215
Note:
Install the follower roller so that the side
with the bearing
{
1
faces outward.
3) Insert the one-way clutch fitting part
{
1
into the hole
{
2
in the document pressure.
Insert the end
{
3
into the square hole of
the top cover (base).
Figure 3-216
4) Install the spring
{
1
and unit
{
2
and the
follower roller (with a coil spring)
{
3
on the
shaft.
Figure 3-217
Note:
When passing the shaft, install the
follower roller so that the side with the
coil spring
{
1
of the follower roller faces
outward.
Figure 3-218
