COPYRIGHT © CANON ELECTRONICS INC. 2012
CANON P-208 FIRST EDITION
3-9
CHAPTER 3 DISASSEMBLY & REASSEMBLY
5) Tilt the document pressure
{
1
in the di-
rection of the arrow, and assemble it to the
fitting parts
{
2
of the upper unit.
Figure 3-219
6) Slide the shaft so that the flat part of the
center of the shaft touches the end surface
of the spring, and install the follower roller
holder.
Note:
If the position of the flat part of the
center is correct, the flat part
{
1
at the
end of the shaft is on the upper side.
Figure 3-220
