4. Install the security chip in socket J23 on the new motherboard.
NOTE:
Be sure to align the small notch in the security chip with the notch in the outline that appears inside socket J23.
If you install the security chip incorrectly, you may corrupt the security chip and/or the motherboard.
1
2
3
Figure 16: Aligning the security chip
No.
Name
1
J23
2
Security chip
3
Align notches
■ Replacing the motherboard
Use the following procedure to install the motherboard in the
imagePASS
chassis.
● To replace the motherboard
1. If you are installing a new motherboard, do the following:
• Remove the security chip from the old motherboard and install it onto the new motherboard (see
).
• Install the DIMM(s) from the old motherboard onto the new motherboard (see
• Install the CPU from the old motherboard onto the new motherboard (see
“CPU and CPU cooling assembly” on page
When installing these components, make sure that the motherboard is placed on an antistatic surface with some padding.
Do not transfer the BIOS chip from the old motherboard onto the new motherboard. Doing so can cause the system to shut
down due to incompatibility issues.
3. REPLACING PARTS
30
Summary of Contents for imagePASS-R1
Page 6: ...Introduction 1 Introduction 2 Specifications 7 ...
Page 15: ...Using the imagePASS 2 Using the imagePASS 11 ...
Page 19: ...REPLACING PARTS 3 Replacing Parts 15 ...
Page 51: ...INSTALLING SYSTEM SOFTWARE 4 Installing System Software 47 ...