I
NSTALLING
H
ARDWARE
14
I
NSTALLING
H
ARDWARE
Installation problems are easier to avoid and diagnose if you proceed from the component to
the system level and verify functionality at each stage. The following procedure should take
place:
• Preparing for hardware installation or service procedures (see
)
• Installation sequence (see
)
• Checking the customer site (see
• Unpacking the imagePRESS Server (see
)
• Installing the imagePRESS Server and connecting it to the copier and the network (see
)
• Completing the installation (see
)
–
Print a Test Page and a Configuration page.
–
If the imagePRESS Server requires a static IP address (for example, in a non-DHCP
network environment), work with the network administrator to configure it
as described on
–
Remind the site administrator to install the current user software on networked
computers that print to the imagePRESS Server (see
Printing
and
Utilities
, which are
part of the user documentation set.
Installation sequence
Because the imagePRESS Server is a node on the customer’s computer network, make sure
that you coordinate your scheduled installation with the network administrator at the
customer site. For Network Setup information, refer the network administrator to
Configuration and Setup
, which is part of the user documentation set.
N
OTE
:
You can change the default language that is preinstalled at the factory using the
Configure tool available through Command WorkStation and WebTools. Start Configure,
choose Fiery Server > Regional Settings > Server Language, and then click Save, and then
reboot the imagePRESS Server. It takes up to three minutes to change languages.
1 Check installation requirements and verify site conditions.
If possible, obtain verification that the network is operational (see
).
2 Unpack the imagePRESS Server (see
).
3 Connect the monitor, keyboard, mouse, and furniture to the imagePRESS Server if applicable.
For more information on setting up the furniture, see
Furniture, 19-inch Monitor, Keyboard,
and Mouse for PRO Series.
