I
NSTALLING
H
ARDWARE
15
4 Connect the interface cables (see
).
• Copier interface cable
• Network cable (upper RJ-45)
• Ethernet crossover cable (lower RJ-45)
5 (Optional) If the imagePRESS Server requires a static IP address (for example, in a non-DHCP
network environment), work with the network administrator to configure it (see
).
6 Complete the installation (see
).
Remind site administrator to install current user software on networked computers that print
to the imagePRESS Server (see
Printing
and
Utilities
, which are part of the user
documentation set).
Checking the customer site
Before you install the imagePRESS Server, check site conditions and inform the customer of
any installation requirements.
F
IGURE
1:
Space requirement for the imagePRESS Server
Copier readiness
• Is the copier configured for use with the imagePRESS Server? (For the proper settings, see
the documentation that accompanies the copier.)
• Is space available near the copier for the imagePRESS Server and the furniture?
Make sure that adequate space is available for the imagePRESS Server and the furniture.
Allow enough space at the connector panel for the cables to route easily and at the side panel
so that the imagePRESS Server does not interfere with use of or service to the copier (such as
clearing a paper jam). You may need to move the copier away from the wall so that
the interface connectors are accessible.
• Does the copier require service or adjustments?
Print the copier Test Page before you install the imagePRESS Server.
If the image indicates that the copier needs adjustment, inform the customer. After getting
approval, complete the necessary copier service.
Connector panel
Side panel
20cm+ (8 in.)
imagePRESS Server
20cm+ (8 in.)
