Canon ImagePRESS Server H350 V2 Service Manual Download

Page: 18 / 117

Installing Hardware

About the installation process

It is strongly recommended that you review this chapter before you install the imagePRESS Server. Also keep in mind that
installation problems are easier to avoid and diagnose if you proceed from the component level to the system level, verifying
functionality at each step.
Since the imagePRESS Server is connected to the customer’s network, be sure to coordinate your installation schedule with the
administrator at the customer site. For information about network setup, refer the site administrator to Configuration Guide, which
is part of the user documentation set.
If necessary, you can change the default language of the imagePRESS Server set at the factory (see

“Change the language of

the imagePRESS Server” on page 11

■ To install the imagePRESS Server

1. Check installation requirements and verify site conditions.

If possible, obtain verification that the network is operational (see

“Network” on page 12

)

2. Unpack the

imagePRESS Server

(see

“Checking the customer site” on page 11

)

3. If applicable, connect the monitor, keyboard, mouse, and furniture to the

imagePRESS Server

For more information on setting up the furniture, see the documentation that comes with the furniture kit.

4. Connect the following cables (see

“Connecting the imagePRESS Server” on page 13

)

• Power cable
• Printer interface cable
• Network cable (upper RJ-45)
• Crossover Ethernet cable (lower RJ-45)

5. (Optional) If the

imagePRESS Server

requires a static IP address (for example, in a non-DHCP network environment), work

with the site administrator to configure a static IP address (see

“Configuring a static IP address for the imagePRESS Server”

on page 17

)

6. Complete the installation (see

“Completing installation” on page 18

)

Remind site administrator to install current user software on client computers that print to the

imagePRESS Server

(see

Printing and Utilities, which are part of the user documentation set).

■ Change the language of the imagePRESS Server

If necessary you can change the language of the imagePRESS Server set at the factory.

To change the imagePRESS Server language from Fiery QuickTouch

1. On the Fiery QuickTouch Home screen, select Quick Launch > Settings (see Figure 10 on

“Overview of Fiery QuickTouch

menu options” on page 22

2. Log in to the imagePRESS Server as Administrator.

The default password for the Administrator is

Fiery password

(See

“How to obtain the Fiery password” on page 8

3. Select Language, and then from the Select language drop-down, select the language you want.
4. Press Save Changes.
5. Press Reboot.

Wait until the imagePRESS Server reboots and becomes Idle. It may take up to 15 minutes to complete the system language
change.

To change the imagePRESS Server language from Configure

1. Access Configure (see

“About Configure” on page 21

2. In Configure, click Fiery Server > Regional Settings,
3. In the Server Language drop-down list, select a language.
4. Click Save.
5. Click Continue, then click Reboot.

Wait until the imagePRESS Server reboots and becomes Idle. It may take up to 15 minutes to complete the system language
change.

Checking the customer site

Before you install the imagePRESS Server, check the site conditions and inform the customer of any installation requirements.

2. INSTALLING HARDWARE