Follow these steps to change the
Trim Edge First
setting.
1
On the
Tab Selection screen
of the Control Panel, press
◀
or
▶
to
select the Paper tab (
).
Note
•
If the
Tab Selection screen
is not displayed, press the
Menu
button.
2
Press the
OK
button.
The
Paper Menu
is displayed.
3
Press
▲
or
▼
to select
Paper Details
, and then press the
OK
button.
4
Press
▲
or
▼
to select the type of paper, and then press the
OK
button.
5
Press
▲
or
▼
to select
Trim Edge First
, and then press the
OK
button.
6
Press
▲
or
▼
to select the desired setting option, and then press the
OK
button.
This setting takes effect the next time you load a roll.
Reducing Dust from Cutting Rolls
Reducing Dust from Cutting Rolls
For media such as Backlit Film that are more likely to generate debris when cut, select
CutDustReduct.
>
On
in
the
Paper Menu
of the Control Panel. This option reduces debris from cutting by printing black lines at the leading
and trailing edges of documents. It may help prevent Printhead damage. You can specify for
CutDustReduct.
to be
activated for particular types of paper.
Important
•
Do not set
CutDustReduct.
to
On
for paper that wrinkles easily, such as Plain Paper or lightweight paper. This
may impair cutting and cause paper jams.
•
Borderless printing is not available when
CutDustReduct.
is set to
On
. To use borderless printing, select
Cut-
DustReduct.
>
Off
.
Set
CutDustReduct.
to
On
as follows.
1
On the
Tab Selection screen
of the Control Panel, press
◀
or
▶
to
select the Paper tab (
).
Note
•
If the
Tab Selection screen
is not displayed, press the
Menu
button.
Reducing Dust from Cutting Rolls
iPF785
Handling and Use of Paper
Handling rolls
356
Summary of Contents for imageprograf IPF785
